This article assumes you know how to open and use the fix‑up panel. If you’re new to fix‑ups, please read Using the fix‑up tool in Artworker.
Open the fix‑up panel and enable “Generate bleed”
In the Dimensions section of the fix‑up tool, switch on the Generate bleed toggle to activate the bleed options.
Setting your bleed amount
In the Generate bleed section, enter the bleed you want to add.
You can choose to:
Apply the same bleed to all sides
Or enter different bleed values for each side if your artwork requires it
If the job includes a bleed preflight check, Artworker will pre populate the bleed value for you based on your preflight settings.
Bleed generation methods
Artworker offers several ways to create bleed. Choose the one that best suits your artwork.
Automatic
Artworker analyses the page edge and extends artwork intelligently.
Stretch
Edge pixels are stretched outward to create a smooth extension.
Mirror
The artwork edge is mirrored to form the bleed. Good for photography and repeating patterns.
Pixel repetition
A thin strip of edge pixels is repeated to create a consistent block of bleed.
Colour handling
Bleed is currently generated in CMYK.
If your artwork is RGB, the added bleed may appear slightly darker due to colour space conversion.
We plan to support RGB bleed generation in the future, helping the generated bleed match RGB artwork more closely.